Automatic safety systems, Emptying the liquid detergent tank, D 19 – Fagor FET-6412D User Manual
Page 23

• Water safety system:
During operation, constant control of the water prevents any overflows.
• Spin safety system:
Your washing machine is fitted with a safety system that restricts the spin
when poor load distribution is detected.
In this case, your washing may be insufficiently spun. Redistribute your
washing in the drum and programme a new spin.
• Anti-foam system:
Your machine can detect when too much foam is being produced during
spinning.
At such times, spinning stops and the machine drains.
The cycle then restarts, adapting the spin rates and possibly adding an
extra rinse.
• AUTOMATIC SAFETY SYSTEMS
• Lid opening safety system:
As soon as washing commences, the lid on your machine is locked.
When the cycle is finished or when the machine has stopped with the
drum full of water, the lid unlocks.
If you have selected a delayed wash, the lid remains unlocked throughout
the waiting period until the cycle actually starts.
If you wish to open the lid during the cycle, press button «Start/Pause»
briefly and wait 1-2 minutes for the safety system to unlock the lid.
Important:
Depending on when you wish to open the lid during the cycle,
this time delay may be a little longer because a cooling down period
may also have to be included.
In fact, to avoid your being severely burnt, the lid safety system will
not open during the cycle unless the temperature inside the machine
is below a certain threshold.
23
6
4 / PROGRAMMING YOUR MACHINE
EN
5 / MAINTAINING YOUR MACHINE
• Programmed emptying
(Diagram D19)
With your appliance switched on, enter the distribution system setting mode
by pressing the «Temperature» and «Spin» buttons at the same time.
Then press the «Dose-e» and «Intensive» buttons at the same time.
The duration of the emptying phase is displayed in the «Remaining time»
zone and the emptying phase starts immediately.
NB: If at the end of the emptying phase, you notice that there is detergent
remaining in the tank, programme as many additional emptying phases as
necessary.
Warning:
If you want to clean your tank thoroughly, when it is completely
empty, put water into it and then empty programmed.
• EMPTYING THE LIQUID DETERGENT TANK
You may have to empty all or part of the liquid detergent tank.
— You want to empty a very small quantity of detergent, for example,
you are changing detergent and do not want to mix the new one with the
remainder of the old one (even if the tank level is below minimum, there is
always some detergent remaining in the distribution system).
In this case, you have the option to programme emptying.
Warning:
In this case, the detergent is discharged by the emptying hose
to the sewer system.
D 19