Fagor TK-500 - Manual (Page 11)

10
4. BEFORE USING YOUR KETTLE
Before using your kettle for the first time
or after a long period of disuse, fill to the
maximum, boil and then pour the water
away.
water; do not move the product when
it is SWITCHED ON. The kettle can be
dangerous if these precautions are not
taken.
• WARNING: If the kettle is too full, the
boiling water may splash out.
pre-established temperature, i.e. 100ºC,
showing 99ºC on the LED screen.
• While the water is boiling, you can
readjust the temperature to boil the
water with the “+” or “-” keys. If the
temperature is higher than the previous
temperature, the kettle will continue
boiling the water. Otherwise, if the
temperature is lower, the element will not
function.
• While the kettle is heating the water, the
digits on the screen will flash. When the
temperature of the water to be boiled
reaches the preselected temperature,
these digits will stop flashing.
• The kettle will count two minutes and
then go into standby mode. You can do
this yourself by pressing before
these two minutes pass. when the water
inside reaches boiling point.
• Do not add more water to the kettle
while it is switched on.
• Do not leave water in the kettle for long
periods or overnight.
5. HOW TO USE YOUR
AUTOMATIC KETTLE
• Place the appliance on a dry, flat, stable
surface.
• Open the lid by pressing the
corresponding button (2) and fill with
the required quantity of water. The water
level should be between the ‘MAX’ and
‘MIN’ marks.
• Replace the lid and make sure it is
properly fitted, otherwise the kettle will
not switch itself off when the water boils.
• Place the kettle on the base, plug into
the mains.
• To turn on the appliance, if you first
press the “+” or “-” button, the screen
will show the temperature of the water
that is in the kettle. After 10 seconds, if
you do not set anything, nothing will be
displayed on the screen, the kettle will
return to standby mode. If you continue
pressing one of these (“+” “-”) the
temperature will rise or fall. Then press
the button, the screen will flash
continuously and the kettle will go into
water boiling mode. If you press
again, the LED screen will displayed
nothing, the kettle will return to standby
mode.
• Otherwise, if in the first instance you
press and then the “+” or “-”
button to select the desired temperature,
the kettle will go into water boiling
mode. If you only press the
button, the appliance will reach the
6. KEEP HOT FUNCTION
This appliance also has a function for
keeping the water hot.
Once you have turned on the kettle, you
can select the temperature you wish with
the “+” or “-” buttons. Then press the
’button and then press . The
kettle will start the process of keeping the
water hot, and this process will continue
for a maximum period of one hour. As the
process continues, the screen will show a
dot at the bottom right.
During the keep hot process, if you press
the ‘ ’ button, it will come out of the
keep hot function and return to the water
boiling mode.
When the kettle goes into the keep hot
mode, the circuit begins to count the
time, and after one hour nothing will be
displayed on the screen; the kettle will
return to standby mode. During the one-
hour period, if you press the button,
nothing will be displayed on the screen and
the kettle will return to standby mode.