Decolav 5246 - Manual (Page 7)

JORDAN MODULAR SERIES
Customer Service: 561-274-2110
www.decolav.com LET YOUR DREAMS COME ALIVE, YOUR PASSIONS
BECOME REALITY, BE THE ENVY OF YOUR NEIGHBORS ®
7
Customer Service: 561-274-2110
www.decolav.com LET YOUR DREAMS COME ALIVE, YOUR PASSIONS
BECOME REALITY, BE THE ENVY OF YOUR NEIGHBORS ®
Factory installed
insert nuts
Connecting Bolt (4 Total)
INSTALLING THE SINK TO THE VANITY TOP
o The Sink and the Vanity Top
o Lay the top upside down on the Floor
o Using Epoxy (not included) glue the four brass inserts (Figure F) into their respective holes.
o Allow cure time per epoxy manufactures recommendations.
Step #1
Apply Epoxy to Each Hole
Vanity Top
Brass Insert
Figure F
There are 2 holes on each end panel of the
vaity. The holes are bored half way through
the panel from the factory. Customer will
bore holes all the way through. Bore all both
hole through the panel when hooking up
the Drawer Console or the Vanity Drawer.
Flat Washer (4 total)
Connecting
Wood Screw
Small Wood Screw
(12 total)
T-Nut (4 total)
Connecting
Bolt (4 Total)
Flat Washer
(4 total)
T-Nut (4 total)
Small Wood
Screw (12 total)