Decolav 1755 - Manual (Page 2)

Please contact 1-866-332-6528 for further assistance
DecolaV.com
© Deco laV, inc. 2014
2
assembly instructions
• make sure not to crimp or pinch wire for safe connections. Plug in the
power cord
connecting the Power 2
• raise Wall mounted mirror above Wall cleat and lower mirror cleat into
• position. see figure 2
• Gently push down on the top of the Wall mounted mirror to ensure
the cabinet cleat and wall cleat are fully seated into position. the Wall
mounted mirror should be fully against the wall when cleats are fully
seated
• slight side to side adjustments can be made by lifting up slightly on the
cabinet or sliding the cabinet left and right
mount mirror to finished wall 3
• carefully remove your new mirrored cabinet from carton and place safely
aside
• Determine at what height the wall cleat is to be hung. mark with pencil
• using a level, make a horizontal line where the mirror cabinet is to be
hung that is parallel to the floor
• Place the Wall cleat on this line in the desired location and mark for the
drywall anchor holes (note: if a hole will hit a wall stud use a screw instead
of a drywall anchor)
• Drill holes for the drywall anchors and install drywall anchors
setting uP your new wall mounted
mirror 1
ethanPointe mirror with led lighting
item #1755-tsW / 1755-WeG
note: two individuals are recommended for installation of this
product.
figure 1
figure 2 figure 3
Finished Wall
Wall screw
Wall screw
Wall cleat
Wall Hole
Wall cleat
Mirror
Finished Wall
power supply
Power supply
Finished Wall
Wall screw
Wall screw
Wall cleat
Wall Hole
Wall cleat
Mirror
Finished Wall
power supply
Power supply