4 replacing the display/display cable – Beijer Electronics iX Panel K70 EN User Manual

Page 24

Hardware Replacement

8.4 Replacing the Display/Display

Cable

The following is needed:

•

A new display including plastic frame and display cable, see

•

A torx T10 screwdriver

Note:
Make sure to use adequate ESD protection.

Follow the steps below to replace the display/display cable:
1. Power off the operator panel.
2. Follow the instructions under

to remove the rear

cover.

3. Disconnect the three ﬂex cables from the power card, according to the

illustration below, and remove the two plastic nuts that hold the power card
in place.

plastic nut

flex cables

4. Lift the power card and gently remove the backlight cable from the rear side.

backlight cable

snap-in closure for plastic frame

guide pins

5. Gently loosen the complete plastic frame and display from the front plate.

Scrap the display and frame.

6. Mount the new display/display cable and frame and re-assemble the complete

operator panel. Make sure the guide pins on the frame are properly fastened in
the holes in the front plate.

Beijer Electronics, MAEN002