beautypg.com

Air kit 2 – American Bicycle Security Company Air Kit 2 User Manual

Page 4

background image

American Bicycle Security Company

P.O. Box 7359

Ventura, CA 93006

Ph: (800) 245-3723 or (805) 933-3688

Fax: (805) 933-1865

www.ameribike.com

Email:

[email protected]

Air Kit 2

Installation Steps:

Please note: All threads for all parts of the pump are right-hand threads. They tighten clockwise, and loosen
counterclockwise (“righty tighty, lefty loosey”). However, when you are looking top-town at a bolt that
threads from underneath, if you move it counter-clockwise from your point of view, you are actually
tightening, not loosening, the nut! This has led to some unnecessary breakage of pump parts. Be sure you
are looking at the nut with the proper orientation before tightening or loosening.

Maintenance & Repair

Changing the Pumphead

Remove the black heat-shrink

covering the base of the

pumphead. Unscrew the

pumphead from the

Brass fitting by turning

counterclockwise. You will

need to keep the brass fitting

for the new pumphead.

Replace the pumphead. If you

will be replacing the heat

shrink then put the heat-

shrink sleeve over the hose

before replacing pumphead.

Once pumphead is on, pull
heat-shrink sleeve over the

brass fitting and use a heat

gun to shrink it.

Brass fitting

1.

2.

Maintenance:

1. Remove tamper-resistant screws, lock

washer and spacer.

2. Plunger assembly may now be pulled out.

To replace gaskets, pry old gaskets off

and clean piston. Apply new silicone

grease and install new gaskets. Apply

more silicone grease to new gaskets. Re-

assemble and wipe off excess grease

when done.