Fixit – American Bicycle Security Company Fixit User Manual
Page 3
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865
Fixit
Installation
Tools Needed for Installation
Hammer drill
3/8” masonry bit
Hammer
Socket Wrench
9/16” socket
Tamper-proof socket (included)
Socket extension, 6” min.
Instructions:
1. Reference the Fixit setback recommendations and place the
upright in the desired location. Use the base as a template
and drill (4) 3/8” x 3” holes in the concrete with a hammer
drill and masonry bit. Clean up all concrete dust from drilling.
2. Hammer in the (4) wedge anchors. Leave at least ¾” of an inch of exposed
threads above the Fixit base.
3. Decide which position the pump will be installed in and place
the bottom pump flange over the corresponding wedge anchor.
Attach the top pump flange to the Fixit upright with a carriage
bolt, washer, and tamper-proof nut. Tighten all wedge anchors
with washers and nuts.
4. Insert the tool cables into the cable slot on the Fixit upright.
5. Place the bike hanger in the desired position on top of the Fixit upright and
attach with carriage bolts, washers and nuts.
1.
2.
3.
4.
5.