Dero decker – American Bicycle Security Company Dero Decker User Manual
Page 5
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865
Dero Decker
Installation Instructions –
Double Sided
Installation Steps:
1. Refer to setback diagrams before installation to ensure sufficient space. Installation surface must be level. If surface is not
level, contact an American Bicycle Security Company representative for workable solution.
2. Place both Uprights in position and place the Cross Beam on top of the Uprights.
Secure the Cross Beam to each Upright with at least two 5/8 x 5.5” bolts placed
diagonally from each other.
3. After checking that the unit is square and that the minimum setbacks have been
achieved, anchor the Uprights to the floor with 6 wedge anchors each.
4. Remove the CROSS BEAM and place DOWN CANTILEVER ASSEMBLIES on top of the UPRIGHTS. Place
the CROSS BEAM on top of the UPRIGHTS and CANTILEVER ASSEMBLIES and secure the CROSS BEAM to
each UPRIGHT with at least two 5/8 x 5.5” bolts placed diagonally from each other.
5. While supporting the DOWN CANTILEVER ASSEMBLY, remove the 5/8 x 5.5” bolts and place an UP
CANTILEVER ASSEMBLY and secure with for 5/8 x 5.5” bolts. Repeat for the other UPRIGHT.
6. Starting at one end of the CROSS BEAM and working your way to the other, place a DOWN
CANTILEVER ASSEMBLY and an opposing UP CANTILEVER ASSEMBLY in place and secure them with four
5/8 x 5.5” bolts. Check to make sure the CANTILEVER ASSEMBLIES are at 90º to the CROSS BEAM.
After tightening the fourth bolt, retighten all four bolts. Repeat until all open CROSS BEAM positions are
filled.
7. Place the LOWER TRAYS in position on the ground with alternating UP
and DOWN LOWER TRAYS. The LOWER TRAYS should be in between the
CANTILEVER ASSEMBLIES. The front edge of the UP and DOWN LOWER
TRAYS are coincident and 62” from the back edge of the UPRIGHT base
flange. Secure the LOWER TRAYS to the ground with wedge anchors.