Cycle stall elite – American Bicycle Security Company Cycle Stall Elite User Manual
Page 3
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865
Cycle Stall Elite
*Tools Needed for Installation
Tape Measure
Marker or Pencil
Masonry Drill Bit 3/8”
Drill (Hammer drill recommended)
Hammer
Wrench 9/16”
Installation
Installation Steps:
Recommended Base Materials:
A concrete base is the best surface for installation.
For installation into asphalt, separate asphalt
anchors and instructions will be sent with the rack.
Installation:
Attach the Cycle Stall segments on street with the
supplied 3/8” x 2.75” carriage bolts, and move
assembled unit into place. 3/8” anchors are shipped with
the rack. Be sure nothing is underneath the base material
that could be damaged by drilling. Place the rack in the
desired location. Use a marker or pencil to outline the
holes of the flange onto the base material. Drill the holes
in accordance with the specifications shipped with the
anchors. Make sure the holes are at least 6” away from
any cracks in the base material. Tap in anchors and
follow your specific anchor instructions provided with the
rack.
Tamper Resistant Fasteners:
The concrete spike is a permanent anchor. The
top of the wedge anchor can also be pounded
sideways after installation so that it cannot be
removed. Other tamper resistant fasteners are
also available for purchase. When using the
special tamper resistant nuts, always set and
first tighten the anchors. Once the rack is
installed, replace two nuts from the bracket
(opposite sides from each other) with the
tamper resistant fastener. DO NOT
OVERTIGHTEN the tamper resistant nut.
2.
1.
2.
3.