Advanced Technology ClearCore - Manual (Page 4)

ATI-Clearcore Fabrication Manual Revision 0 Effective Date: 11/16/05
Page 4
Dimensional Stability.
Sheets will experience an expansion or contraction when exposed to a temperature or
humidity change. Shrinkage will occur when the unclamped sheet is subjected to
forming temperatures, but post-forming stability is excellent.
Flammability
Our sheets are combustible thermoplastic. Precautions should be taken to protect this
material from flames and high heat sources. Rapid burning to completion occurs if not
extinguished. The products of combustion, if sufficient air is present, are carbon dioxide
and water. However, in many fires sufficient air is not present and toxic carbon
monoxide will be formed.
Uses:
Many interior design applications, where decorative HP laminates could be used (Not
recommended for high wear horizontal surfaces). Furniture, Store fixtures, displays,
exhibits, and signage are a few other uses. For exterior application, Clearcore
tm
can be
used for automotive interiors and exteriors, boat dashboards, outdoor signage and much
more.
Important Disclaimer and Warranty : The information and statements contained herein are not to be
taken as a warranty or representation for which we assume any legal responsibility. The information is offered
solely for your consideration, investigation and review. Users must perform their own test to insure the
products are applicable and suitable for any particular purpose.
The Seller warrants that the products sold hereunder shall be of merchantable quality and shall conform to the
specification herein. However, the buyer assumes all risks. The only remedy to the buyer shall be for the seller
at its sole option to either replace the sheets which are deemed to be defective or refund the purchase price. The
seller makes no warranty; express or implied based on the fitness of the product for any purpose other than
stated herein. The seller shall not be liable for any additional loss whatsoever, including a claim for breach of
merchantability, any incidental, or collateral damage or loss, It is the buyer’s responsibility to inspect the
product upon receipt and prior to any fabrication. Any claim whatsoever shall be deemed waived once any
fabrication or cutting is started. Any claim shall also be deemed waived unless presented in writing within ten
days of receipt of said product. It is the sole responsibility of the purchaser to do the necessary tests to insure
that these products meet the purchaser’s requirements. NO WARRANTY IMPLIED OR OTHERWISE
SHALL APLY to products that undergo manufacturing
.
Revised January 22, 2004