Advanced Technology ClearCore - Manual (Page 3)

ATI-Clearcore Fabrication Manual Revision 0 Effective Date: 11/16/05
Page 3
1st time users should request a sample piece (approx. 1 x 2-ft.) to check their fabrication
and lamination techniques.
The BOTTOM FILM MUST BE REMOVED prior to applying adhesive.
TOP FILM is to remain in place during fabrication to prevent against scratching during
the fabrication process. However it is extremely import to visually inspect the sheet prior
to fabrication to insure that there are no visible defects that can’t be accepted. In the
event that inspection can not be adequately inspected with the top mask on the customer
must remove the mask prior to fabrication to inspect the sheet. Then the customer must
re-mask the sheet with another mask prior to starting fabrication.
Storage
Before any fabrication, sheets must be conditioned for a minimum of 48 hours in the
same room as the substrates. 70F and relative humidity of 50% is recommended.
Masking should be left in place on both surfaces (if applicable) until fabrication.
Sheets should be stored horizontally completed supported or vertically at a slight angle in
an A frame type rack.
Insure that the sheets are not stored near heat sources that can deform the sheets.
Care and cleaning
Use only Naphtha or Mineral spirits to remove excess adhesive. Avoid using Acetone,
MEK’s, etc. as these may damage the surface.
Use a mild soap solution that does not contain alcohol or ammonia. Use a soft lint free
cloth to dry.
DO NOT use any abrasive cleaners as these will dull and scratch the surface.
Characteristics
Our (optional) 1/8 acrylic performs like standard acrylic. Our High Performance
modified acrylic (standard) .060 thickness (designated by HP in the part #), is rigid and
tough, lightweight and offers ease of fabrication and machining. Cutting, routing, and
cementing can be performed. Clearcore
tm
offers the look of acrylic with extra impact
strength to aid in fabrication, shipping, handling, and prevent edge chipping.
All sheets come with a removable polyethylene mask to protect the sheet during
handling, shipping and fabrication. Most are suitable for interior or exterior applications.