Westwood Design Jonesport Convertible Crib - Manual (Page 6)

Step 2
A. Open all 4 support arms on the spring platform as shown in the drawing.
B. Place a screw through the stabilizer bar as shown, then through the support
arm on the spring. Thread on a wing nut and tighten securely.
C. Repeat for the remaining three support arms.
D. Set the spring to the desired height by adjusting the support arms. The spring
should be at its highest setting for newborns, then adjusted to the lower positions
as the child grows and becomes mobile. Once the child is able to stand, the
spring should be at its lowest position.
E. Insert a screw through the appropriate hole in the frame, then through the
support arm, and thread on a wing nut, tightening it securely.
F. Repeat for the remaining three support arms.
Required Hardware
8 x Phillips Screw (K)
8 x Wing Nut (L)
Phillips Screw (K)
Wing Nut (L)
Support Arm
Highest
Lowest
Middle