Vaddio SDI Slot Card for Vaddio ClearVIEW HD-18/20 - Manual (Page 6)

WallVIEW CCU HD-18 HD-SDI
WallVIEW CCU HD-18 HD-SDI Manual 341-988 Rev. A Page 6 of 26
The Components (continued)
Rear Panel Connections and Controls (Left to Right):
Power Supply Input:
36V 2.78 Amp power supply on a 5.5mm OD x 2.5mm ID connector. Only use the power supply
provided.
Power on RJ-45:
Power is provided on a CAT 5e cable to EZIM HD-SDI Card.
RS-232 IN on RJ-45:
RS-232 Input from ProductionVIEW HD-SDI, Precision Camera Controller, or a third-party controller.
Daisy Chain control is not supported.
RS-232 OUT on RJ-45:
The RS-232 Output from the CCU is connected to the RS-232 Input on the HD-18 camera.
Tally on 2-pin Phoenix type connector:
Contact Closure lights LED on front panel allowing indication of which QCCU/camera combination is
active in a multi-camera/CCU installation. A tally command will also be sent to the camera to illuminate
the LED on the camera.
G/L Input on BNC-F:
This option is not supported on the HD-18 camera.
Camera Feature Switches:
The CCU interface has an 8-position dip switch on the rear panel to allow certain functionality as it relates
to other Vaddio products and for future use.
Y-Gain:
The Y-Gain adjustment is not supported with the EZIM HD-SDI Slot Card system.
Distance:
The Distance Adjustment is not supported with the EZIM HD-SDI Slot Card system.
Video Outputs:
The video outputs on the back of the Quick-Connect CCU are not supported or used with the HD-SDI
Slot Card system. The SDI signal is fed on a coax cable directly from the back of the EZIM HD-SDI slot
card at the camera to the HD-SDI Console or monitor or over HD-SDI signal destination.
Video RJ-45
The EZCamera Power/Video RJ-45 port is not supported with the CCU/HD-SDI system.
+ G
Figure 5: Quick-Connect HD-18 CCU Rear Panel