Asus INTEL 850 ATX - Manual (Page 19)

HP WMT-LX Manual 19
13)USB2/3 Headers (10-1 pin USB2/3)
If the USB Ports on the back panels are inadequate, a USB header is
available for two additional USB ports. Connect the 10-1 pin ribbon
cable from the provided 2-port USB connector set to the midboard 10-1
pin USB header and mount the USB connector set to an open slot on
your chassis.
WMT-LX USB Port
RJ-45 Top:
WMT-LX
1
2
11
12
GND
GND LP2– LP2+ SBV2
LP3– LP3+ SBV3
USB23
12)Wake-On-LAN Connector (3-pin WOL)
This connector connects to a LAN card with a Wake-On-LAN output,
such as the HP PCI-L101 Ethernet card (see 7. Appendix). The connec-
tor powers up the system when a wakeup packet or signal is received
through the LAN card.
IMPORTANT: This feature requires that Wake On LAN or PCI Mo-
dem is enabled (see 4.5.1 Power Up Control) and that your system has
an ATX power supply with at least 720mA +5V standby power.
RJ-45 Top:
WMT-LX
WMT-LX Wake-On-LAN Connector
IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power
+5 Volt Standby PME
Ground
WOL_CON
+001-023 WMT-LX.p65 copy 3/23/01, 9:32 AM 19