Silver King SKFS - Manual (Page 2)

1
TECHNICAL MANUAL
SILVER KING MODELS SKDI AND SKFS COOLIE
Thank you for purchasing Silver King food service equipment. Our goal is to provide our customers
with the most reliable equipment in the industry today. Please read this manual and the accompany-
ing warranty information before operating your new Silver King unit. Be sure to complete and mail the
warranty card within 10 days of purchase to validate your warranty.
INSPECT FOR DAMAGE AND UNCRATE
Upon delivery of your new Silver King unit, uncrate at once to inspect for possible damage following
the instructions printed on the exterior of the container. Report any damages to the carrier responsible
for transportation and promptly present a claim for any evidence of mishandling.
INSTALLATION
Model SKFS
The Model SKFS has a stainless steel exterior that has been protected by a plastic covering during
manufacturing and shipping. This covering can be readily stripped before installation. After removing
this covering, wash the interior and exterior surfaces using a warm, mild soapy water solution and a
sponge or cloth. The Model SKFS has louvered panels at the bottom front and rear of the cabinet.
When installing the unit, these areas require a minimum spacing of six (6) inches to allow proper
airflow to the condensing unit and to maintain the compressor warranty!
Model SKDI
The Model SKDI is designed to drop into a counter or bar for convenient serving. A square cutout of
16.5 inches by 16.5 inches is required to drop the cabinet into the countertop. The counter must be
able to support a weight of at least 125 pounds or the unit should be supported from the bottom. Once
installed into the countertop a bead of silicone should be placed around the perimeter of the top to
prevent moisture from seeping through. When installing the unit into a countertop it is extremely
important to provide adequate air circulation to the condensing unit to maintain the compressor war-
ranty! If the cabinetry is not vented to allow the warm condensing unit discharge air to escape, you will
need to provide holes in it for that purpose. The suggested method for venting is to cut 8.5 inch square
holes in the counter directly in front of the condenser and directly behind the compressor. Once
installed the interior and the exposed exterior surfaces should be washed using a warm, mild soapy
water solution and a sponge or cloth.
LOCATION
When locating your Silver King Frozen Treat Case, convenience and accessibility are important con-
siderations, but the following installation guidelines must be followed;
• Always avoid placing the unit next to an oven, heating element or hot air source that would affect the
operation of the unit.
• Follow the installation guidelines above for proper airflow.
• The unit must be level.