Audiovox Prestige P153B - Manual (Page 10)

To play the CD tracks in the programmed order, press the PGM
button. PGM will appear on the display, and the tracks on the
CD(s) will play in the desired order.
To clear the programmed CD tracks, press the MEM CLR button
for more than 3 seconds. M -- CL will appear on the display and the
programmed tracks will be erased.
do
DISPLAY (DISP) BUTTON
During disc play, the elapsed time of the current track is displayed
when this button is pressed once; when pressed a second time,
the remaining playing time on the current track will be displayed.
Pressing the button again (a third time) will revert to the track number
display.
dp
DISC EJECT ( )
During CD player operation, disc play is stopped and the disc is
ejected when the front panel is folded down and this button on
the front of the chassis is pressed. Radio or CD changer operation
will automatically resume depending on which mode was in
operation prior to disc play. If the disc is not removed from the
unit within approximately 10 seconds of being ejected, it will
automatically be re-loaded into the unit to prevent it from being
accidentally damaged ( will appear on the display panel to
indicate that a disc is loaded in the player). Play of the disc can
be resumed by using the play/pause (
) button to choose CD
player function.
dq
TIME/FREQUENCY SELECTOR (T/F)
During radio operation, press this button to call the time display on
the quartz clock. The display will return to the radio frequency
indication after 5 seconds.
-10-
During integral CD player or cassette player operation,or during CD
changer operation, a press of the button will call the time display,
but tape or disc play will continue uninterrupted. If the time of day
is not adjusted within 5 seconds, the display will return to the play
mode currently in effect.
dr
THEFT-DETERRENT LED
Located on the chassis behind the front panel, a Light Emitting
Diode (LED) will flash when the panel is removed. The flashing
light serves as a visual warning to the would-be thief that the unit
has been disabled by removal of the front panel.
ds
RESET BUTTON
A RESET button is also accessible behind the front panel and
can be used to activate the reset circuitry. However, this feature
should only be activated under the following circumstances as it
will erase the time and pre-set memories:
1. Upon initial installation after all wiring is completed.
2. If there is a malfunction of any of the switches on the unit,
pressing the RESET button may clear the system and permit
a return to normal operation.
dt
FRONT PANEL RELEASE BUTTON (R)
This button is used to release the mechanism that holds the front
panel to the chassis. To detach the front panel, press the button
so that the panel drops to the lowered position. Press the
RELEASE bar at the front edge of the panel and slide the panel
off of the front mounting plate. After removing the panel, push the
front mounting plate back up to the vertical position.