Power Soak 36212 PS-275 Owner's Manual - Manual (Page 19)

15
Timed Unload/Load
The Power Soak PS-275 is equipped with programming and alert lights to
monitor the wash cycle. If enabled, this feature will time wash and
Unload/Load cycles and then signal the operator when it is necessary to
transfer the wares to the next step. The work flow should take place as
follows:
1. Drop off soiled items on a soiled landing area like the soiled drain
board.
2. Remove the scraps and fill the wash tank with a full load of items to
be washed. The program will time a wash cycle.
3. At the completion of the timed wash cycle the green beacon will
flash.
The flashing beacon indicates that the timed wash cylce has expired
and an unload/load cycle should be performed.
4. When an operator arrives to perform the unload/load cycle, they
should first press the Load/Unload button on the control panel.
The green flashing beacon will turn solid to acknowledge the
operators action.
5. The dry, sanitized items should be moved to their designated
storage location.
6. All of the items should be removed from the sanitizer tank and
arranged for air drying on the clean drain board.
7. All of the clean items should be removed from the wash tank, rinsed
and placed in the sanitizer tank. When necessary some finishing
(light hand scrubbing) may be necessary.
8. Remove the scraps from a full wash load of items and place them in
the wash tank.
9. When these tasks are complete, press the Load/Unload button
on the control panel. The solid green beacon will turn off to
acknowledge the completion of the unload/load cycle. The wash
timer will be started and the cycle will repeat. The operator may
return to other duties.
Between cycles, soiled items should be dropped off on the soiled drain
board or other soiled ware landing area.