Power Soak 36212 PS-275 Owner's Manual - Manual (Page 15)

11
allows an operator to begin filling the wash tank, and return to other duties.
When the tank is within a few minutes of completing its fill, the blue and
green beacons will flash in an alternating pattern.
When the top liquid level sensor detects that the unit is full, the pattern will
speed up to communicate urgency that the water needs to be turned off.
Rinse Water
Submersion Rinsing
If the wares are to be rinsed by submersing them in fresh water, fill the
rinse tank (middle tank) with water that is approximately room temperature,
75°F/24°C. The hot and cold taps on the faucet are used to adjust the
water to the appropriate temperature. Drain and refill this tank as
necessary to maintain clean water in the tank.
Spray Rinsing
When using the faucet or hand held spray nozzle to rinse the wares, leave
the wash tank empty, with the drain open.
Sanitizer Water
Direct Dispensing
Fill the sanitizing tank using the faucet with water that is approximately
75°F / 24°C prior to adding chemicals. The hot and cold taps on the faucet
are used to adjust the water to the appropriate temperature. When the
tank is full, the chemical can be manually added to the water. Never place
concentrated chemicals into an empty tank. If the machine is equipped
with the Power Soak Chemical Dispensing system, the control system of
the machine will dispense the chemical when the wash pump is started.
Metered or Pre-Mixed Dispensing
If the machine is filled using a metered chemical dispensing system the
introduced water temperatures should be approximately 75°F / 24°C. The
hot and cold taps on the faucet can be used to adjust the water to the
appropriate temperature. Some machines are supplied with a set of mixing
valves that pre-mix the water to the correct temperature. The temperature
adjustments for these valves are located on the front of the valve. When
using a dispensing system, do not add water using the faucet. Water that
is added by a source other than the mixing system will dilute the sanitizing
solution which will reduce its effectiveness and violate health codes.
Optional Sanitizer Tank Filling Alerts
The PS-275 controller can help reduce labor and wasted chemical in the
filling process by signaling the operator that a sanitizer tank fill is nearly