Power Soak 34774 PS-225 Service Manual - Manual (Page 18)

12
Membrane Error – In the event that one of the control panel buttons sends a constant
signal to the UPM, the program will recognize that the membrane is defective and
display this error code (see Section 6.9 Push Button Membrane).
Note: There are periods of unstable power from the incoming power source that can
cause a false error. Turning the electrical power off and on can reset the program if it is
a power source fluctuation that caused the error. Locate the wall mounted circuit
breaker box, turn the circuit breaker for the Power Soak machine off, pause for 15
seconds, turn the circuit breaker back on, and then check to see if the error code has
cleared.
The error codes will have to be reset by a procedure that can be explained by the
Power Soak Service department (1-800-444-9624). Please have the “Error Code”
information available when calling Power Soak Systems for telephone assistance. The
machine serial number will also be helpful to identify the configuration of the machine.
The serial number is 5-6 digits long and located on the identification tag which is on the
lower corner of the wash tank close to the control panel enclosure.