Merrychef 402s - Manual (Page 10)

10
RUNNING A PROGRAM
Using number pad keys to run a program
Programs 0 to 499 can be recalled using the number pad keys.
The following procedure should be used to activate these programs.
( Programs are installed from a MenuKey see page 11)
Press the program number pad(s) you wish to activate
(0-499).
The program number and the program name will appear
on the display.
The program will now operate with the
total remaining time displayed counting
down on the display (all stage time added
together).
When the time reaches “00:00” the
display shows cooking completed and an
audible signal will be given.
Taking all the necessary precautions to
ensure you do not burn yourself remove the
food from the oven and close the door.
example: Program 8
To heat the oven up to its pre-set cooking temperature
press the PREHEAT/COOLDOWN Pad.
The oven will take approximately 20 minutes to reach
the preset temperature, the display will show the
current oven cavity temperature during warm up.
The display will then show READY AT TEMP
° F
when cooking temperature is reached.
1 Switch the oven ON
The display briefly shows the model
no., software issue and MenuKey No.
before showing the OVEN COLD
standby screen.
3
2
Taking all the necessary precautions to
ensure you do not burn yourself, place the
food into the hot oven cavity and close the
door.
Press START Pad to begin cooking
Always keep the period that the door is open
to a minimum.
4
Programs can be halted and cancelled at
any time by pressing the CANCEL key.
Warning: the oven will remain at the pre-set
cooking temperature and food inside the
oven will
OVEN COLD
Press Preheat
example: 2minutes 35seconds
READY AT 525 ° F
RUN PROGRAM - - -
PROGRAM 008
PROGRAM NAME
02.35
Hot surface
hazard
READY AT 525 ° F
RUN PROGRAM - - -
example:
preset temperature 525
° F
COOKING
COMPLETED
PROGRAM NAME