ARCHOS TV+ User Manual
Page 65
MANUAL
V1.0
TV+
THE TV PRoGRAM GUIdE > P. 65
Select the “
Test power Off code
” button. Make sure that your tuner is on. Your
ARCHOS device will then try to turn your tuner off. After a few seconds, your
ARCHOS will ask you if the device responded correctly:
If your tuner turned off, select “
Yes
”, and move on to the next section.
If your tuner did not turn off, select “
No, try next code
”. Your device will try turn-
ing the tuner off again, using a different code. Repeat this operation until the
ARCHOS manages to turn the tuner off.
If none of the codes work, check that the ARCHOS is positioned in a way that
allows the infrared signal to reach your tuner’s receiver. Note: In some rare
cases the ON/OFF functionality may not work.
nd
Test: changing channels on your tuner
After you select “
Yes
” at the end of the 1
st
test, the following screen appears. It allows
you to correctly set the parameters so that the ARCHOS can change channels on your
tuner (for a scheduled recording).
For the “
Channel
” parameter, select the highest channel that is currently memo-
rized on your tuner.
Select the “
Test channel select
” button. Make sure that your tuner is on. Your
ARCHOS device will then attempt to switch your tuner to the selected channel.
After a few seconds, your ARCHOS will ask you if the device responded correctly:
If this worked, select “
Yes
”.
If this did not work, select “
No, try next option
”. Your device will try again to
switch your tuner to the selected channel, using a different option*. Repeat this
operation until it successfully changes the channel on your TV receiver.
*Here is a description of the different parameters automatically set by the ARCHOS:
“Key Delay”:
delay between the emission of each digit of a channel (“
Short
”, “
Normal
”, “
Long
”).
“Key: Enter”:
Set to “
On
” if normally, you have to press an “
OK
” button on your turner’s remote control
after you enter the channel number. Example: If you normally press 1, 3, “
OK
” to access channel 13, then
this parameter is set to “
On
”.
4.
1.
2.
-
-