American Dryer Corp. AD-360X2 - Manual (Page 20)

16
If local codes permit, power to the dryer can be made by the use of a flexible U.L. listed power cord/pigtail
(wire size must conform to rating of dryer), or the dryer can be hard wired directly to the service breaker
panel. In both cases, a strain relief must be installed where the wiring enters the dryer.
Electrical power connection examples:
IMPORTANT: For a 120v installation, a 2-wire service (L1 and Neutral) and a ground is required for
each basket (tumbler)/pocket. In the case of a 208v or 230/240v 1-phase (1ø)
service, 3-wires (L1, L2 and Neutral) and a ground is required for each basket
(tumbler)/pocket.