American Megatrends III - Manual (Page 13)

Chapter 1 Hardware Installation 9
Set Jumpers
Set all jumpers and install the CPU before placing the motherboard in the
chassis. Set jumpers by placing a shunt (shorting bridge) on the designated
pins of the jumper. A shunt and jumpers are shown below:
Shunt 3-pin Berg 2-pin Berg
In this manual, jumpers are shown in two -dimensions,
as if viewed from directly above, as shown below:
1
3
5
2
4
6
The placement of shunts is
indicated by a solid line
between pins, as shown
between Pins 1-2
to the right:
1
3
5
2
4
6
3-dimensional view of motherboard jumpers and a shunt.
Avoid Static Electricity
Static electricity can damage the motherboard and other computer
components. Keep the motherboard in the anti-static bag until it is to be
installed. Wear an anti-static wrist grounding strap before handling the
motherboard. Make sure you stand on an anti-static mat when handling the
motherboard.
Avoid contact with any component or connector on any adapter card, printed
circuit board, or memory module. Handle these components by the mounting
bracket.