ATTO Technology 3400 - Manual (Page 26)

i ATTO FibreCenter 3400 Ins tallation and Operation Manual
Index: Command Line Interface
A summary of the Command Line Interface commands, their defaults, an example of how they might be
used, and where you can find the specifics of the command. Commands which have no default values
associated with them have a blank entry in that column of the table.
Command Default Example Page
Default Router 0.0.0.0 set•RACK •000•Default•Router•0.1.0.1 15
Echo on set•RACK •000•echo•off 15
Factory Defaults set•RACK •000•factory•defaults 15
Flush flush•000 17
Idle Timeout 60 minutes set•RACK •000•idle•timeout•30 15
IP Address 192.168.1.1 set•RACK •000•ip•address• 10.0.0.1 15
Rate set•RACK •000•rate•1•1•2 17
Reset reset•rack•000 17
Security Traps 3 set•RACK •000•security•traps•2 15
Setup setup•000:0120 17
Status get•status•000 16
Subnet Mask 255.255.255.0 set•RACK •000•subnet•mask• 255.255.0.0 15
Switch get•switch•000 17
Switch Delay 20000 µsec. set•switch•delay•20005 17
Telnet Telnet 15
Telnet Status get•RACK •000•Telnet•status 15
Version get•RACK •000•version 16