ALESIS QS8.1 - Manual (Page 97)

Part 6: Editing Effects
QS7.1/QS8.1 Reference Manual 91
DELAY INPUT LEVEL
Range of Settings: <99 to <0> to 99> Page 2 (Config. 2 only)
This parameter is only available on Send 1 in Configuration #2. It adjusts the level of
the signal running from the Delay output to the Pitch Input.
If the chosen Pitch type is Mono Chorus, Stereo Chorus, Mono Flange, or Stereo Flange, then
Page 2 through Page 5 of the Pitch function will contain the following four parameters:
WAVEFORM SHAPE
Range of Settings: Sine/Square Page 2
This determines the LFO’s waveform shape. This parameter only appears when the
Mono or Stereo Chorus or Flange are selected. The Waveform Shape of the LFO can
be changed from a sine waveform, which provides a smoother, more even sound, to
a square waveform, which makes the Chorus or flange effect more pronounced.
SPEED
Range of Settings: 00 to 99 Page 3
This parameter adjusts the LFO Speed of all Pitch types, with the exception of Pitch
Detune and Resonator.
DEPTH
Range of Settings: 00 to 99 Page 4
This parameter adjusts the LFO Depth of all Pitch types, with the exception of Pitch
Detune and Resonator. The LFO Depth, which is the amount of pitch alteration, can
be adjusted to produce the desired effect.
FEEDBACK
Range of Settings: 00 to 99 Page 5
This parameter adjusts the LFO Feedback of all Pitch types, with the exception of
Pitch Detune and Resonator. A portion of the output of the Pitch section can be “fed
back” into the input in order to make the effect more tonal or pronounced.
The following three parameters only appear if the Pitch type is set to Pitch Detune or
Resonator, respectively.
DETUNE
Range of Settings: -99 to +99 Page 2 (Pitch Detune only)
If the Pitch type is Pitch Detune, page 2 will have only this parameter. This adjusts
the tuning of the Pitch Detune effect. This can be set between -99 and +99, in 1 cent
increments.