Vm9510ts, Multi-zone operation – Audiovox VM9510TS User Manual

Page 17

VM9510TS

submenu appears in a second row with the selected
option highlighted in light blue.

Select a new value by pressing the

or buttons (14,

22) on the remote control or the or buttons (18, 19)
on the joystick.

Confirm your selection by pressing the ,

, or

buttons (14, 17, 19) on the remote control, or the or
button (16, 17) on the joystick. The new value is
highlighted in light blue and setup is complete.

Exiting the System Setup Menu

To exit setup mode and resume normal playback, press the
SYS SETUP button (31) on the remote control or the DISP
button (5) on the front panel.

MULTI-ZONE OPERATION

Independent sources can be played simultaneously on the
VM9510TS. For example, a video game console can be seen
on the front screen while DVD video is available to rear
passengers.

NOTE: If DVD is selected as the front source and SD

Card is selected for the rear source, then both sources

will switch to SD Card. If SD Card is selected as the front

source and DVD is selected for the rear source, then

both sources will switch to the DVD source. Since the

multimedia processor is shared between optical and SD

Card media, one of the other can be selected but not

both simultaneously.

Selecting a Source for the Front Zone
To access the FRONT ZONE SOURCE MENU, touch the
TFT screen in the top left corner of the screen.

This menu allows you to select a source for the front zone.

Selecting a Source for the Rear Zone
To access the rear zone SOURCE MENU, touch the top right
corner of the screen, near the Multi-ZONE icon.

Select the source to be directed to the rear Multi-ZONE RCA
outputs.

NOTE: Optical media and an SD Card cannot be selected

from the Multi-ZONE Source Menu simultaneously.

NOTE: The AM/FM tuner graphics will change to a "blue

screen" background when any optical or SD Card media

is selected from the Multi-ZONE menu. In addition, only

the top left (Front Zone Source Menu) and right (Multi-

ZONE Source Menu) quadrants of the touch screen are

active during this mode of operation.

Table 7: ASP Config Menu Features

Setting

Options

Function

Bass Center

Freq

60Hz

According to the audio source, select

the Bass Center Frequency to

achieve the best Bass effect.

80Hz

100Hz

130Hz

150Hz

200Hz

Treble Center

Freq

10KHz

According to the audio source, select

the Treble Center Frequency to

achieve the best Treble effect.

12.5KHz

15KHz

17KHz

Sub.W Filter

80Hz

Selecting a crossover frequency sets

a cut-off frequency of the subwoofer's

LPF (low-pass filter) and the

“SMALL” speakers' HPF (high-pass

filter). The Crossover frequency set-

ting has no effect if the subwoofer is

set to “OFF” and any other speaker is

set to “LARGE”.

120Hz

160Hz

Sub.W Phase

Subwoofer output IN phase

180D

Subwoofer output OUT OF phase

NOTE: Depending on your installa-

tion, reversing the subwoofer phase

may increase Bass output.

Bass Q-Factor

1.0

When the Bass Center Frequency is

selected, adjusting the Bass Q-Fac-

tor alters the sharpness of the Bass

output.

1.25

1.5

2.0

BACK

Return to previous menu.