Alpine VOLUME 1.3 - Manual (Page 5)

To use the WARBLE TONE GENERATOR:
1. Turn Tone Generator on by selecting either "LOW" for a low amplitude signal (usually recommended for
small containers) or "HIGH" for high amplitude. In high, the Warble Tone Generator will cover up to
4,000 cubic feet (121.9 cu. meters) of unobstructed space.
When the Tone Generator is on, a red light (located below the recharge jack in the front) flickers.
2. Place the Warble Tone Generator within the test item/container and seal or close it. Then scan the
suspect areas with the Scanning Module in the Ultraprobe and listen for where the "warble"
ultrasound penetrates.
As an example, if the item to be tested is the seal around a window, place the Warble Tone Generator
on one side of the window, close it and proceed to scan on the opposite side.
4. HEADSET
This heavy duty headset is designed to block out intense sounds often found in industrial environments so that
the user may easily hear the sounds received by the ULTRAPROBE. To use, simply plug the headset cord into the
headset jack on the metered pistol housing, and place the headphones over your ears. If a hard hat is to be worn, it
is recommended to use UE Systems' model UE-DHC-2HH Hard Hat Headphones which are specifically
designed for hard hat use.
A. For those situations in which it is not possible or difficult to wear the standard headphones
described above, UE Systems has two options available: 1. the DHC 1991 Earpiece which loops
around the ear, and 2. the SA-2000 Speaker Amplifier which is a loud speaker that is compatible
with the Ultraprobe headphone output jack.
5. WTG-1 WARBLE TONE GENERATOR (OPTION)
The WTG-1 Tone Generator is an ultrasonic transmitter designed to flood an area with ultrasound. It is used for a
special type of leak test. When placed inside an empty container or on one side of a test item, it will flood that area
with an intense ultrasound that will not penetrate any solid but will flow through any existing fault or void. By
scanning with the Scanning Module, empty containers such as pipes, tanks, windows, doors, bulkheads or hatches
can be instantly checked for leakage. This Tone Generator is a WARBLE TONE GENERATOR. This internation-
ally patented transmitter sweeps through a number of ultrasonic frequencies in a fraction of a second to produce a
strong, recognizable "Warble" signal. The warble tone prevents a standing wave condition which can produce false
readings and provides for a consistency of testing in practically any material.
-3-
To test the condition of the Warble Tone Generator battery, set to the LOW INTENSITY position and
listen to the sound through the Ultraprobe headphones. A smooth continuous warbling sound should be heard.
If a "beeping" is heard instead, then a full recharge of the Warble Tone Generator is indicated.
To charge the Warble Tone Generator:
1. Use the recharger.
2. Plug the recharger cord into the recharge jack located on
top of the front panel.
3. Plug the recharger into the local current supply
4. A complete charge will take 7 hours.
5. Since there is no memory problem, the Tone Generator
may be charged after short intervals of use.
WTG1 WARBLE TONE
GENERATOR (OPTIONAL)