Audiovox AWM-710 - Manual (Page 4)

INSTALLATION AND HOOK-UP
NOTE: Always be sure when running cables to avoid sharp edges, extreme heat sources, and any other potential hazards.
2
1. Cut mounting hole in desired location using mounting hole
diagram (right).
2. Route power, speaker, and antenna cables through hole
and connect to unit as shown below.
3. After making sure connections are correct, test unit
operation as described in operation section.
4. For best AM reception, AM trimmer must be adjusted.
COLOR
BLACK/WHITE
WHITE
VIOLET
BLUE
RED
VIOLET/BLACK
YELLOW
LT.GREEN/BLACK
LIGHT GREEN
ORANGE/WHITE
B SPEAKER LEFT (+)
B SPEAKER LEFT (-)
B SPEAKER RIGHT (+)
B SPEAKER RIGHT (-)
A SPEAKER RIGHT (-)
A SPEAKER LEFT (-)
A SPEAKER RIGHT (+)
+12VDC IGNITION HOT
GROUND
A SPEAKER LEFT (+)
FUNCTION
FOR AWM-710
WIRING COLOR CODE
12 PIN FEMALE CONNECTOR
Notes:
- When hooking up two speakers, hook A+ and A- speaker
wires to speaker select A speaker on switch. A & B and B
will not have any output at this time.
- B speakers are optional
- Speakers must have a minimum of four ohm impedance
each.
- Either antenna may be used. Both do not have to be hooked
up at the same time.
- Do not operate this unit with only one speaker hooked up. If
a speaker fails, replace it before operating this unit.