Hardware installation, Switch installation, Ethernet port connection – Abocom SW2400M User Manual
Page 5
- 3 -
HARDWARE INSTALLATION
The switch is considered as a “plug and play” network device and requires no special
setup procedures. Connect the power cord and cables correctly and you are ready to go.
Switch installation
1.
Put the switch on the appropriate location. When you install the switch, there are
two things needed to be considered:
Ÿ
Location: Your switch should be located in a place that is central to your
home/office space and allows all computers and networked devices connected to
your switch.
Ÿ
Power: Remember to locate your switch near electrical outlet.
2.
Power on the switch by connecting the power cord.
3.
Verify if the power (POWER) LED is on. If the POWER LED does not light up,
check the power cord and power outlet to verify its connection. If it still remains
unlit, please contact your dealer for support.
Ethernet Port Connection
Connect user machines, servers, another switch, hub, or any other devices to the Ethernet
ports on this switch with either straight through or crossover Ethernet cables.