Scarlett SC-335S - Manual (Page 4)

www.scarlett-europe.com SC-335S 4
GB INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS
· Please read all instruction manuals before use and save it for future references.
· Before first switching on check that voltage indicated on the rating label corresponds the mains voltage in your
home.
· For home use only. Do not use for industrial purposes. Use the steam iron only for its intended use.
· Do not use outdoors or in damp area.
· Do not immerse the steam iron and cord in water or other liquids.
· Never pull the cord while disconnecting from the power outlet; instead, grasp the plug only and pull to disconnect.
· Do not allow the cord to touch sharp edges and hot surfaces.
· Always unplug the steam iron from the power supply when filling with water or emptying and when not in use.
· Do not operate the steam iron with damaged cord or plug, or after the appliance malfunctions, or has been dropped
or damaged in any manner. To avoid the risk of electric shock, do not disassemble the steam iron; take it to a
service center for examination, repair or mechanical adjustment.
· Keep the appliance away from children. Close supervision is necessary when the appliance is used near children.
· Do not leave the iron unattended while hot or connected or on an ironing board.
· While ironing interrupted, stand iron on heel rest only, do not place the steam iron on metal or rough surfaces.
CAUTION: To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
BEFORE THE FIRST USE
· Some parts of the steam iron have been slightly greased and as a result the iron may slightly smoke when
switched on for the first time. After a short time this will cease.
· Remove protection cover from the soleplate and clean it with a soft cloth.
HOW TO USE
SETTING TEMPERATURE
· Always check first to see whether a label with ironing instructions is attached to the article to be ironed. Follow
these instructions in all cases.
LABEL TYPE OF TEXTILE
Do not iron this article
Synthetics, Nylon, Acrylics, Polyester, Rayon
Wool, Silk
Cotton, Linen
MAX Maximum temperature (Steam)
· Insert the mains plug into the wall socket. The LCD highlight and indicator light off will now turn on.
· Press (t) button to set appropriate temperature.
· The sound signal will be heard after each pressing. Heating will start and the display will show blinking standby
indicator and corresponding temperature setting.
· After the blinking standby indicator dissapeared you can start ironing
· If you set the temperature control to lower setting after ironing at a high temperature, do not recommend ironing
before the blinking standby indicator will apear.
THE WATER TANK FILLING
· Unplug the iron before filling.
· Turn detachable anti calc cartridge counter-clockwise and take it out.
· Slowly pour water through the water inlet
· Do not fill higher than mark on the water tank, in order to avoid spilling out of water.
· Do not use chemically de-limed water or perfumed.
· If you have too hard water,it is advisable to use only distilled or demineralized water.
· The water tank should be emptied after each use.
NOTE: If you empty the water tank after the steam iron has cooled down, set the steam iron in an upright position on
its heel rest, plug it in and set the temperature control dial to the maximal position, heat for 2 minutes. Unplug the
steam iron from the power supply.
SPRAYING
· As long as there is enough water in the water tank, you may use the spray button at any temperature setting either
on steam or dry ironing.
· Press the spray button several times to activate the pump while you are ironing.
· Press the spray button slowly for a dense spray and quickly for a vaporized spray.
STEAM IRONING
· Set the temperature control dial to the MAX or position.
· Set the variable steam control to the middle position.
CAUTION: Avoid coming in contact with ejected steam.
DRY IRONING
· The steam iron can be used on the dry setting with or without water in the water tank, however it is best to avoid
having the water tank too full while dry ironing.
· Turn the variable steam control to the minimum position.
· Select the setting on the temperature control dial best suited for the fabric to be ironed.