Panasonic DMWMCTZ3E - Manual (Page 12)

12
VQT1F26
Preparation
-Setting the O-ring- (continued)
4
Inspect the opposite side of the O-ring in the same way.
5
Apply the grease (supplied).
≥ Apply a rice-grain size of grease (supplied) evenly to the O-ring with the tip of
your finger.
≥ Dirt or dust will stick to the O-ring if you apply too much grease.
≥ Use only the specified grease. If you use other types of grease, the
surface of the O-ring may be damaged causing water leakage.
≥ Do not apply the grease with paper or a cloth. The fibers from the paper or cloth
may stick to the O-ring.
6
Fit the O-ring evenly into the O-ring groove.
Check the following:
≥
There is no dirt sticking to the O-ring.
≥
The O-ring has not come out.
≥ The O-ring is not twisted.
≥
The O-ring is not stretched too much.
CORRECT
INCORRECT
VQT1F26.book 12 ページ ２００７年２月６日 火曜日 午前１１時１８分