Scarlett SC-137S - Manual (Page 5)

www.scarlett-europe.com SC-137S 5
NOTE: If you empty the water tank after the steam iron has cooled down, set the steam iron in
an upright position on its heel rest, plug it in and set the temperature control dial to the maximal
position, heat for 2 minutes. Unplug the steam iron from the power supply.
SPRAYING
· As long as there is enough water in the water tank, you may use the spray button at any
temperature setting either on steam or dry ironing.
· Press the spray button several times to activate the pump while you are ironing.
STEAM IRONING
· Set the temperature control dial to the or position.
· When indicator light is off, the steam iron has reached desired temperature.
CAUTION: Avoid coming in contact with ejected steam.
DRY IRONING
· The steam iron can be used on the dry setting with or without water in the water tank,
however it is best to avoid having the water tank too full while dry ironing.
· Turn the variable steam control to the minimum position.
· Select the setting on the temperature control dial best suited for the fabric to be ironed.
CAUTION: If the steam iron has been used for a long time, is hot and there is no water. Do not
refill it with water until the steam iron has cooled down.
BURST OF STEAM
· The burst of steam feature provides additional steam for removing stubborn wrinkles.
· Turn the temperature control dial to the or position.
· Turn the variable steam control to the maximum position.
· Press the steam burst button to release the burst of steam.
NOTE: To prevent water leakage from the soleplate, do not keep the steam burst button
pressed for more than 5 seconds.
VERTICAL STEAM
· Ensure that there is enough water in the water tank.
· Stand the steam iron on its heel rest on an iron-safe surface and plug it.
· Set the temperature control dial and variable steam control to their maximum positions.
· Hold the iron vertically and press the steam burst button, an intense steam will be ejected
from the soleplate.
WHEN YOU FINISHED IRONING
· Turn the variable steam control to the minimum position.
· Remove the mains plug from the wall socket.
· Stand the iron on heel rest.
CARE AND CLEANING
· Before cleaning the steam iron ensure it is unplugged from the power supply and has
completely cooled down.
· Do not use abrasive cleaners.
WATER TANK CLEANING
· Fill the half of the water reservoir.
· Set the temperature control to its maximum position.
· Insert the main plug into the wall socket.
· Allow the iron to heat up until the indicator light goes out.
· Unplug the steam iron.
· Holding the iron horizontally over the sink, change the steam control to the maximum
position.
· Boiling water and steam will be ejected from the holes in soleplate with impurities washed
out.
· Move the iron over an old (preferably) piece of cloth. This to ensure that the soleplate will be
dry during storage.
STORAGE
· Unplug the appliance from the power supply, empty the water tank (do it after each use) and
allow steam iron cool down completely.
· Wrap the cord around the heel rest.