Scarlett SC-137S User Manual

Page 4

www.scarlett-europe.com

SC-137S

INSTRUCTION MANUAL

IMPORTANT SAFEGUARDS
· Please read all instruction manuals before use and save it for future references.

· Before first switching on check that voltage indicated on the rating label corresponds the

mains voltage in your home.

· For home use only. Do not use for industrial purposes. Use the steam iron only for its

intended use.

· Do not use outdoors or in damp area.

· Do not immerse the steam iron and cord in water or other liquids.

· Never pull the cord while disconnecting from the power outlet; instead, grasp the plug only

and pull to disconnect.

· Do not allow the cord to touch sharp edges and hot surfaces.

· Always unplug the steam iron from the power supply when filling with water or emptying and

when not in use.

· Do not operate the steam iron with damaged cord or plug, or after the appliance

malfunctions, or has been dropped or damaged in any manner. To avoid the risk of electric
shock, do not disassemble the steam iron; take it to a service center for examination, repair
or mechanical adjustment.

· Keep the appliance away from children. Close supervision is necessary when the appliance

is used near children.

· Do not leave the iron unattended while hot or connected or on an ironing board.

· While ironing interrupted, stand iron on heel rest only, do not place the steam iron on metal

or rough surfaces.

CAUTION: To avoid a circuit overload, do not operate another high wattage appliance on the
same circuit.
BEFORE THE FIRST USE
· Some parts of the steam iron have been slightly greased and as a result the iron may slightly

smoke when switched on for the first time. After a short time this will cease.

· Remove protection cover from the soleplate and clean it with a soft cloth.
HOW TO USE
SETTING TEMPERATURE
· Always check first to see whether a label with ironing instructions is attached to the article to

be ironed. Follow these instructions in all cases.

· Turn the temperature control dial round to set the appropriate temperature indicated in the

ironing instructions or in the fabric label.

LABEL

TYPE

TEXTILE

Do not iron this article

Synthetics,

Nylon,

Acrylics,

Polyester,

Rayon

Wool,

Silk

Cotton,

Linen

Insert the mains plug into the wall socket. The indicator light will now turn on.
· When the indicator light has gone out - you can start ironing

· If you set the temperature control to lower setting after ironing at a high temperature, do not

recommend ironing before the pilot light switches on again.

THE WATER TANK FILLING

· Unplug the iron before filling.

· Hold the steam iron in the horizontal position.

· Slowly pour water through the water inlet.

· Do not fill higher than mark on the water tank, in order to avoid spilling out of water.
NOTE: Your steam iron is designed to use tap water. However, if the water is very hard, it is
advisable to use distilled water.
· The water tank should be emptied after each use.