Panasonic NTDP1 - Manual (Page 6)

10 11
English
Parts Names and Handling Instructions
Size of bread  
8~13 cm
8~12 cm
Thickness:
1~2 cm Insert the bread with the longer side facing down. •
If the bread is too large, thick, thin or bread with uneven surfaces, it may get •
jammed or caught inside of the toaster.
If the bread is too small, it may get caught inside of the toaster or pop it up.
•
If bread gets jammed, unplug the toaster, let it cool, and carefully remove the •
bread. Otherwise it will keep toasting. Don’t use anything sharp to remove the
bread, you’ll damage the heating elements.
Note
When using the toaster for the first time, there may be a small amount some smoke or smell. This will disappear  ●
with usage.
The illustrations inside mainly show model NT-ZP1.
Please remove the protection seals from the appliance before use.
Safety Precautions Please make sure to
follow these instructions.
CAUTION
Pay attention to the appliance when it is in use.  
(It may cause fire.)
When leaving it, turn the power off. ●
Make sure the crumb tray is clean and set correctly  
when using the appliance.
(It may cause fire or injury.)
Unplug and allow the appliance to cool down fully  
before cleaning and storing away.
(It may cause burns.)
Do not move the appliance while it is hot. ●
Press down the toast lever only for toasting, never  
block it.
(It may cause burns.)
Make sure to clean the appliance after every use.  
(Otherwise It may cause smoke or fire.)
Important Information
Do not drop the appliance to avoid damaging it. ●
Do not turn on the appliance for purposes other than toasting or ●
warming up bread.
Do not turn on the appliance if the insertion slots are covered
●
with bread.
Do not toast anything other than breads, for example pastries.
●
This appliance is not intended to be operated by means of an ●
external timer or separate remote-control system.
Do not move the appliance by holding the levers, warming rack
●
or insertion slots.
Toast lever
Warming rack lever
Insertion slot
Crumb tray
Slide out to remove.  ●
Mains lead
Warming rack
Browning level
indicator (For NT-ZP1)
Defrost indicator
(For NT-ZP1)
Reheat indicator
(For NT-ZP1)
Mains plug
* The shape of the mains
plug may be different
from illustration.
Cord storage
Store the mains lead  ●
as illustrated. Do not
set the mains lead in
the opposite direction.
Before you store the
mains lead, clean the
toaster as crumbs
may spill out. (P.14)
Before using the toaster,  ●
adjust the length of the mains
lead in these places.
NT-ZP1 NT-DP1
Browning control
button
Browning level
indicator
Defrost button
Reheat button
Stop button