Panasonic ESLA93 - Manual (Page 12)

GB 1
English
. Gently wipe off any beard trimmings
attached to the inside of the cleaning
tray with a cloth or tissue paper
dampened with water.
Clean the corners and uneven parts
of the cleaning tray with a cotton
swab dampened with water. •
Warning ‑ Do not wash or apply water to the adaptor or
self‑cleaning recharger. Failure to observe this may cause
electric shock or result in short circuits.
Do not pull hard on the rubber blade protector at the
bottom of the cleaning tray. The rubber may come off if you
pull hard on it. It is only necessary to pull it up slightly. •
•
When the water does not drain from the
cleaning tray
Beard trimmings may clog the drain at
the bottom of the cleaning tray.
In this case, you cannot clean or dry the
shaver.
Push the beard trimmings down through
the drain with a tooth pick etc.
Replacing the inner blades
1. Press the foil frame release buttons
and lift the outer foil section upwards
as illustrated.
. Remove the inner blades one at a time
as illustrated.
Do not touch the edges (metal parts)
of the inner blades to prevent injury to
your hand.
3. Insert the inner blades one at a time
until they click as illustrated.
•
1
2 3
Cleaning the self-cleaning recharger
Beard trimmings may become attached
to the cleaning tray of the self‑cleaning
recharger. Follow the steps below to
remove them. We recommend doing this
each time you change the detergent
cartridge.
1. Be sure to remove the water tank and
the appliance plug from the self‑
cleaning recharger.
Be careful not to spill the cleaning
liquid. •
