AT&T P5962 - Manual (Page 21)

19
Telephone Operation
Base settings
Ringers
At this menu you can change ring volumes, or turn the
ringers off. You can also select one of six ring melodies. You
will hear an example of each ring volume level and ring type
as you scroll through the choices.
Follow the menu instructions to select the volume and
melody you prefer, then select
OK
or
SAVE
to confirm.
NOTE: Choose different ringer melodies for the two different lines so you can
easily identify which line is ringing .
Call screening
Call screening lets you hear messages at the base as callers
leave them. Select
ON
or
OFF
, then select
OK
to confirm.
NOTE : If you selected OFF you will not hear messages as callers leave them.
Set pulse/tone
Factory default setting for both lines is
TONE
. Change this to
PULSE
only if you do not have touch-tone dialing service
(select line, highlight
TONE
or
PULSE
, then select
OK
).
Keypad tone
The handset is factory programmed to beep at each key-
press. Select
ON
or
OFF
, then select
OK
to confirm.
NOTE: If you selected OFF you will not hear beeps at each keypress.
Contrast
At this menu you can adjust the base screen contrast to one of
16 levels. Use
or to select the level you prefer, then
select
OK
to confirm.
Rename
At this menu you can change the name (up to 14 characters)
that appears on your base screen, and identifies your base in
all Intercom/Transfer menus. See “Rename” on page 18 for
instructions.
Deregister all
Use this option with
EXTREME CAUTION
. It will make all
handsets unusable until each one has been re-registered
(see page 41-43 for more details about deregistering and
re-registering handsets).
+ -
BASE
RDL CID MENU
MAILBOXES
DIRECTORY
SETUP BASE
DISPLAY BASE-ID
^ V OK
CALL SCREENING
RINGERS
SET PULSE/TONE
KEYPAD TONE
^ V SET
CONTRAST
RENAME
DEREGISTER ALL
KEYPAD TONE
^ V SET
Select MENU
Highlight SETUP BASE
Scroll to choose desired item
Select SET
91-000302-050-000_EP5962Englishmanual_Sep.02,2005.qxd 2/13/1950 7:21 PM Page 19