Hitachi CPX3 - Manual (Page 26)

6
IMAGE Menu
IMAGE Menu
Item Description
ASPECT
Using the ▲/▼ buttons switches the mode for aspect ratio.
For a PC signal
NORMAL у 4:3 у 16:9 у 16:10 у REAL
For an HDMI signal
NORMAL у 4:3 у 16:9 у 16:10 у 14:9 у REAL
For a Video signal, s-video signal or component video signal
4:3 у 16:9 у 16:10 у 14:9 у REAL
For no signal
16:10 (fixed)
• This item can be selected only for a proper signal.
• The NORMAL mode keeps the original aspect ratio setting.
• Performing the automatic adjustment initializes the aspect ratio setting.
OVER SCAN
Using the ▲/▼ buttons adjusts the over-scan ratio.
Large (It reduces picture) ó Small (It magnifies picture)
• This item can be selected only for a video, s-video and component video signal.
• When this adjustment is too large, certain degradation may appear
at the frame area of the picture. In such a case, please adjust small.
V POSITION
Using the ▲/▼ buttons adjusts the vertical position.
Up ó Down
• Over-adjusting the vertical position may cause noise to appear on the
screen. If this occurs please reset the vertical position to the default setting.
Pressing the RESET button when the V POSITION is selected will reset the
V POSITION to the default setting.
• When this function is performed on a video signal, s-video signal, or
component video signal, the range of this adjustment depends on the
OVER SCAN (above) setting. It is not possible to adjust when the OVER
SCAN is set to 10.
H POSITION
Using the ▲/▼ buttons adjusts the horizontal position.
Left ó Right
• Over-adjusting the horizontal position may cause noise to appear on the
screen. If this occurs please reset the horizontal position to the default
setting. Pressing the RESET button when the H POSITION is selected will
reset the H POSITION to the default setting.
• When this function is performed on a video signal, s-video signal, or
component video signal, the range of this adjustment depends on the
OVER SCAN (above) setting. It is not possible to adjust when the OVER
SCAN is set to 10.
From the IMAGE menu, items shown in the table below
can be performed.
Select an item using the ▲/▼ cursor buttons, and press
the ► cursor button or ENTER button to execute the item.
Then perform it according to the following table.
(continued on next page)