Sony KDL-70XBR7 User Manual
Page 4

− 4 −
Additional Information for Using Sony Wall-Mount Bracket (SU-WL500)
3
Adjust the angle of the Mounting Hook using the hexagon wrench supplied
with the Wall-Mount Bracket.
When installing the TV parallel to the wall (0 degrees), adjustment of the Mounting Hook angle
(procedures and below) is not necessary. Make sure that each arm base X is screwed in securely.
Remove the two screws from the arm base X of the Mounting Hook. Choose the holes
corresponding to the desired angle (5, 0, 5 or 0 degrees).
Adjust the angles of the top Y and bottom Z arm to fit the corresponding hole, and firmly
secure each arm using the two screws removed in the previous procedure .
Hexagon
wrench
✍
• Be sure to adjust the right and left arms to the same angle.
• Make sure that the two arm bases are screwed in securely.
CAUTION
Be careful not to pinch your fingers when adjusting the angle of the Mounting Hook.
4
Remove the screws from the back of the TV.
Do not remove any other screws from the TV.
5
Lift the TV off the stand. Make sure that you carry out this task with at least four
people.
Do not attempt to lift the TV by yourself.
✍
• Do not place the TV face down or lay flat on its back, the panel may be damaged. Be sure to keep the
TV in its upright position at all times.
• To avoid injury or damaging your TV, have four people position themselves as illustrated above and lift
the TV slowly.