Sony KLH-40X1 - Manual (Page 47)

13 GB
GB
You cannot use the OPTION 2 button on this display.
9 ID MODE (ON/0-9/SET/C/OFF) buttons
You can operate a specific display without affecting other displays
installed at the same time.
• ON button:
Press to show the “Index Number” on the screen.
• 0-9 button: Press to enter the “Index Number” of the display you want
to operate.
• SET button: Press to set the input “Index Number”.
• C button: Press to clear the input “Index Number”.
• OFF button: Press to return to the normal mode.
See page 16.
0 +/ – button
Adjusts the picture (contrast) level.
qa +/ – button
Press to adjust the volume.
qs button
Press to mute the sound. Press again to restore sound.
qd ECO button
Press to reduce the power consumption by adjusting the backlight
brightness. This also enhances the black level. Select from “Off”,
“Low”, “High” or “Picture Off”. See page 16.
qf DISPLAY button
Press to display the currently selected input, the type of the input
signal and the “Wide Mode” setting on the screen. Press again to hide
them. If this displayed information is left undisturbed for a short time,
it will disappear automatically.
qg OPTION 1 button
Press to select the input signal of the VIDEO connector.
qh HD15 button
Press to select the input signal of the HD15 connector. The RGB
signal or component signal is selected automatically in accordance
with the connected equipment.
qj STANDBY button
Press to change the display to the standby mode.
HDMI2 HDMI2
ON ON STANDBY STANDBY
HD15 HD15
ON ON ID MODE ID MODE OFF OFF
SET SET
OPTION1 OPTION1
DISPLAY DISPLAY
ECO ECO SOUND SOUND
PICTURE PICTURE
OPTION2 OPTION2
HDMI1 HDMI1
RM-FW001 RM-FW001
Note