Avenview SW-DVI-2X4 - Manual (Page 8)

www.avenview.com 8
1.10 IR Remote Control
- Press “Menu” to launch OSD and use arrow buttons to select options in the OSD menu.
- Right arrow button allows you to confirm your selection
- Press “Menu” again to exit the OSD menu
Note: Only four arrow buttons and the menu buttons are currently active.
Section 2: Installation
Follow these instructions for installation of SW-DVI-2X4:
1. Connect DVI Y Cable to DVI Input
2. Connect DVI Y Cable to DVI Output 2 and DVI Output 3
3. Connect source 1 and source 2 to the Y Cable that is plugged in to DVI Input
4. Connect display 1 and display 2 to the Y Cable that is plugged in to DVI Output 1
5. Connect display 3 and display 4 to the Y Cable that is plugged in to DVI Output 2
6. Turn the source and output displays ON
7. Plug in power to SW-DVI-2X4