Sony STR-DA5800ES - Manual (Page 77)

77 US
Usi
n
g Mu
lt
i-zon
e
Fe
atur
es
Note
You can connect the HDMI ZONE 2 OUT jack directly to a TV in zone 2 (without any amplifier/receiver). It
is recommended, however, that you connect a TV via an amplifier/receiver for higher audio/video capabilities,
reducing possible effects on the main zone. When you select the same HDMI input for both the main zone and
zone 2, the audio/video capabilities in the main zone will be limited in accordance with those in zone 2.
4 Making a zone 2 connection using ZONE 2 VIDEO OUT (RJ-45
jack)
ZONE 2 VIDEO OUT (RJ-45 jack) is used only for custom installation by a qualified person.
ZONE 2 VIDEO OUT (RJ-45 jack) is a jack that sends a source video signal to the component
video input for zone 2. For details, consult your dealer.
Attention
Do not use this jack for an Ethernet LAN connection. Doing so may cause a malfunction. The router may be
damaged.
ZONE 2 VIDEO OUT (RJ-45 jack) connection
The RJ-45 pinouts use the T568B standard. Refer to the illustration below.
Note
CAV-CVB1 (Component Video Balun) must be used. Other types will cause trouble and may void your
warranty.
Component Video Balun
CAV-CVB1
ZONE 2 VIDEO OUT (RJ-45 jack) CAT5 cable Component video
cable
TV
monitor
Zone 2
continued