Sony STR-DE585 - Manual (Page 32)

32
GB
n A1˜A2˜...˜A0˜B1˜B2˜...˜B0N
n C0˜...C2˜C1N
Tuning to preset stations
You can tune the preset stations by either of the
following two ways.
Scanning the preset stations
1
Press TUNER.
The last received station is tuned in.
2
Press PRESET TUNING +* or PRESET
TUNING –* repeatedly to select the
preset station you want.
Each time you press the button, the receiver
tunes in one preset station at a time, in the
corresponding order and direction as
follows:
* For models of area code CEL, CEK: PRESET/PTY
SELECT + or PRESET/PTY SELECT –.
Using the preset codes
Use the supplied remote to perform the
following operations. For details on the buttons
used in this section, see pages 38-44 for remote
RM-PP506 and pages 45-48 for remote
RM-U306.
1
Press TUNER on the remote.
The last received station is tuned in.
2
Press SHIFT to select a memory page
(A, B, or C), then press the preset
number of the station you want using
the numeric buttons.
Presetting radio stations
1
Press TUNER.
The last received station is tuned in.
2
Tune in the station that you want to
preset using Direct Tuning (page 30) or
Automatic Tuning (page 31).
3
Press MEMORY.
“MEMORY” appears in the display for a few
seconds.
Do steps 4 to 6 before “MEMORY” goes out.
4
Press SHIFT to select a memory page
(A, B or C).
Each time you press SHIFT, the letter “A”,
“B”, or “C” appears in the display.
5
Press PRESET TUNING +* or PRESET
TUNING –* to select a preset number.
If “MEMORY” goes out before you press
the preset number, start again from step 3.
6
Press MEMORY again to store the
station.
If “MEMORY” goes out before you can
store the station, start again from step 3.
7
Repeat steps 2 to 6 to preset another
station.
* For models of area code CEL, CEK: PRESET/
PTY SELECT + or PRESET/PTY SELECT –.
To change a preset number to
another station
Do steps 1 to 6 to preset a new station to the
number.
Preset tuning (continued)