Allied Telesis 86253-07 User Manual
Page 9
Patch 86253-07 For Rapier Series Switches
9
Patch 86253-07 for Software Release 2.5.3
C613-10382-00 REV E
The warning given when a QoS policy is active on a port operating at
reduced speed has been changed to reflect the problem more accurately. The
old message was:
Warning (2087343): Port
policy
due to the port bandwidth.
The new message is:
Warning (2087350): Port
its maximum speed: this may affect QoS policy num>. If the DISABLE SWITCH PORT command appeared in the configuration The root bridge did not transmit BPDU messages with changed hellotime, LDAP could not receive large messages spanning multiple packets. This Files with lines over 132 characters in length could not be transferred using The SHOW FILE command caused an error when the displayed file had a Static DHCP address ranges were not reclaimed if the Reclaim operation was In the output of SHOW FIREWALL EVENT command, the DIRECTION of A small amount of memory was consumed by each ISAKMP exchange if an PCR: 31071 Module: SWI Level: 4 PCR: 31072 Module: SWI Level: 3 PCR: 31082 Module: STP Level: 2 PCR: 31085 Module: LDAP Level: 3 PCR: 31094 Module: FILE Level: 3 PCR: 31096 Module: FFS Level: 3 PCR: 31098 Module: DHCP Level: 3 PCR: 31099 Module: FIREWALL Level: 4 PCR: 31105 Module: ISAKMP Level: 3
script, an interface could come up even though ifAdminStatus was set to
‘down’. This issue has been resolved.
forwarddelay and maxage values. This issue has been resolved.
issue has been resolved.
TFTP. This limit has now been raised to 1000 characters to match the
maximum command line length.
duplicate entry due to file size mismatch. This issue has been resolved. An
error message is now logged when the SHOW FILE command detects a
duplicate file. The first FFS file will be deleted when a duplicate exists.
interrupted by the interface going down. This issue has been resolved.
denied multicast packets was shown as “out”, not “in”. This issue has been
resolved.
ISAKMP policy's REMOTEID was set as an X.500 distinguished name with
the CREATE ISAKMP POLICY command. This issue has been resolved.