Allied Telesis 86253-07 - Manual (Page 17)

Patch 86253-07 For Rapier Series Switches SHOW IGMPSNOOPING ROUTERADDRESS 17
Patch 86253-07 for Software Release 2.5.3
C613-10382-00 REV E
For example, to turn off the Diffie Hellman padding, use the command:
SET ENCO DHPADDING=OFF
Also, the output of the SHOW ENCO command now contains a new line
showing the setting for DHPADDING.
BGP was importing the best route from IP without checking whether the
route was reachable. BGP now selects the best reachable route. If there are no
reachable routes, BGP will select the best unreachable route.
The list of multicast groups for each Rendezvous Point occasionally became
corrupted, and this could cause a fatal error. This issue has been resolved.
BGP routes that were added after a summary aggregate route had been
formed were not suppressed. This issue has been resolved: all routes added
after summary aggregate route creation are also now suppressed.
The SHOW BGP ROUTE command displayed unselected routes as the
"best" route, until they had been processed. This issue has been resolved.
When a single route was deleted from an aggregate route, the aggregate
route was deleted, even if it contained other routes. This issue has been
resolved.
The time recorded when a user logged in was overwritten when the same
user logged in a second time while the original connection was still active.
This meant the SHOW USER command displayed the same time for both
connections. This issue has been resolved.
When an oversize packet (PMTU) was received, an error message was not
returned, even when IPv6 flow was enabled. This issue has been resolved.
With static multicasting enabled on two VLANs, only the first few multicast
packets of a stream were L3 forwarded. This issue has been resolved.
The MLD snooping entries registered on a port were not removed when the
port went down or was unplugged. This issue has been resolved.
Route flapping occurred with BGP when an interface went down. This issue
has been resolved.
When ingress rate limiting was used on Rapier switch ports, TCP sessions
sometimes obtained a throughput that was lower than the configured
ingress rate limit. This issue has been resolved.
PCR: 03704 Module: BGP Level: 2
PCR: 03710 Module: PIM, PIM6 Level: 2
PCR: 03723 Module: BGP Level: 2
PCR: 03726 Module: TTY, USER Level: 3
PCR: 03733 Module: IPV6 Level: 3
PCR: 03734 Module: IPG Level: 2
PCR: 03751 Module: MLDS Level: 3
PCR: 03757 Module: BGP Level: 2
PCR: 03771 Module: SWI Level: 2