Messages – Sony MZ-B100 User Manual

Page 50

-GB

Messages

If the following messages flash in the display window, check the chart below.

Error message

Meaning/Remedy

BLANKDISC

• An MD with no recording on it is inserted.

, Insert a recorded MD.

BUSY

• You tried to operate the recorder while it was accessing the

recorded data.
, Wait until the message goes out (in rare cases, it may take 2–3

minutes).

Data Save

• The MD player is recording information (sounds) from the

memory to the disk.
, Wait until this process is completed. Do not expose the player

to any physical shock, nor disrupt power supply.

DISC ERR

• The disc is damaged or does not contain proper recording or

editing data.
, Reinsert the disc. If this fails, rerecord.

DISC FULL

• There is no more space to record on the disc (less than 12 seconds

available).
, Replace the disc.

EDITING

• You pressed a key on the recorder while editing on the remote

control.

Hi DC in

• Voltage of the power supply is too high (The recommended AC

power adaptor or the recommended car battery cord is not used).
, Use the recommended AC power adaptor (not supplied) or the

car battery cord (not supplied).

HOLD

• The recorder is locked.

, Slide HOLD against the arrow to unlock the recorder

LOW BATT

• Batteries are weak.

, Replace the dry batteries (pages 9, 42).

MEM OVER

• You tried to record with the recorder placed where it receives

continuous vibration.
, Put the recorder on a stable place, and start recording again.

• You pressed a key on the remote control while selecting a menu on

the recorder.

NAME FULL

• You tried to enter more than 200 letters to label a single track or

disc.

• You tried to enter a total of more than 1700 letters for track or disc

names during playback or stop.
, Enter a shorter name for the track, group, or disc (page 34), or

delete “LP:” from the track name recorded in MDLP mode.