Asus Gaming Machine Chassis Kit VENTO 3600 - Manual (Page 18)

C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n 2 - 2 2 - 2 2 - 2 2 - 2 2 - 2
2.1 Preparation
Basic components to install Basic components to install Basic components to install Basic components to install Basic components to install
You need to install the following components to the VENTO 3600 chassis
kit.
1. Motherboard
2. Power supply unit (PSU)
3. Hard disk drive
4. 5.25-inch drive(s)
5. Floppy disk drive(s)
6. Expansion card(s)
Tool Tool Tool Tool Tool
You need a Phillips (cross) screw driver to install some system
components.
2.2 Removing the side panel
To remove the side panel:
1. Remove the cable
management kit by pushing
downward to release the top
tabs.
2. Pull up the cable management
kit to release the bottom
tabs.
1
2
The cable management kit is not a handle. Do not move or lift the
chassis with the cable management kit.