Avanti WDB101 - Manual (Page 4)

4
Your Washer / Dryer Stacking Bracket is designed to accommodate both top loading or front loading
washing machines. Follow the assembly instructions below to assemble the bracket to fit your specific
washing machine type. Images shown in this instruction guide are for assembly for use with a TOP‐Load
washer.
Step 1: Assembling the legs:
When using with a TOP‐ Load washer.
 Assemble the rear legs by screwing together all three sections of the
rear leg.
Part D – Rear Leg (Bottom section)
Part P – Front / Rear Leg (Middle section)
Part E – Front / Rear Leg (Top section)
 Assemble the front legs by screwing together all three sections of the
front leg.
Part F – Front Leg (Bottom section)
Part P – Front / Rear Leg (Middle section)
Part E – Front / Rear Leg (Top section)
When using with a FRONT‐Load washer.
Assemble the rear legs by screwing together only the bottom and top
sections of the rear leg
(Parts D & E).
Assemble the front legs by screwing together only the bottom and top
sections of the front leg
(Parts F & E).
Step 2: Assembling the Bottom Support Frame.
We suggest that you put the U shaped bottom support frame
(Part A) in a vertical position. As this will allow you to insert
the legs and the Shelf / Frame support clips with ease.
a) Lay the Bottom support frame (Part A) on its back with
each side bar facing upwards.
b) Insert each of the rear legs (assembled in step one)
into the holes at both rear corners of the support
frame.
c) Using the Shelf / Frame support clips (Part I) insert the
plastic tapered clips into the appropriate grooves on
each leg. (See the image).
d) Slightly press the bottom support frame downward on
to the support clips.
e) Insert each of the FRONT legs in the remaining corner
holes of the support frame and repeat Step C.
f) Stand the unit upright to continue the remainder of
this assembly.
g) Press each corner downward firmly to ensure the
support frame is fully locked into position.