Sony DPT-S1 - Manual (Page 2)

2
Getting Started
Step 3: Setting up the device
1 Perform initial settings on the device.
Set [Time Zone], [Date & Time Settings], [Pen Grip Style], and
[User Name] from the options displayed.
Note
You can change the initial settings. Press the (Home) button  tap [Settings].
For details, refer to the User Guide.
Step 1: Checking the supplied items
When taking out the Digital Paper device from the box, check
the supplied items.
ˎ ˎ Digital Paper device × 1
ˎ ˎ Stylus × 1
ˎ ˎ AC adapter × 1
ˎ ˎ USB cable × 1
ˎ ˎ Sleeve case × 1
ˎ ˎ Replacement nib × 3
ˎ ˎ Nib puller × 1
ˎ ˎ Quick Start Guide (this guide) × 1
ˎ ˎ Warranty card × 1
Step 2: Charging via an AC outlet
1 Connect one end of the supplied USB cable to the micro
USB connector of your device, and the other end to the AC
adapter.
2 Connect the AC adapter to an AC outlet.
Charge indicator
AC adapter
AC outlet
Note
Charge the Digital Paper device within the recommended temperature range of 5
°C (41 °F) to 35 °C (95 °F). If the room is too hot or cold, disconnect the USB cable
from the device, adjust room temperature accordingly, then reconnect the USB
cable to charge the device.
Tip
ˎ ˎ The Charge indicator will light up red while charging. It will take approximately
2.5 hours to fully charge via AC Adapter.
ˎ ˎ The Charge indicator may blink red 3 times if the  (Power) button is pressed
when the remaining battery is very low. In this case, it may take up to 5
minutes before the Digital Paper device turns on automatically.