Warning, Electro-mechanical coin control tumbler – Alliance Laundry Systems T453I User Manual

Page 15

Operating Instructions

M414462

Figure 3

Electro-Mechanical Coin Control Tumbler

1. Set the TEMPERATURE selector at HIGH or

LOW, or anywhere between these settings.

2. Coin Drop Models: Insert the coin(s) in the coin

slot, turn the knob to the right and release it.
Coin Slide Models: Insert the required number of
coins in the coin slide. Push coin slide in
completely and then release it.

3. Press the PUSH TO START button and hold it for

approximately three (3) seconds.

IMPORTANT: If the cylinder door is opened
during the cycle, the heating system will shut off
and the motor will stop. However, the timer will
continue to run. To restart the cycle, the door must
be closed and the PUSH TO START button must be
pressed in.

4. When the cycle is complete, open door and

remove the laundry.

T366I

PUSH

START

HIGH

TEMPERATURE

LOW

INSERT QUARTER

TURN KNOB

ARTERMASTE

SELECT
TEMP

INSERT
COIN

PUSH
START

TEMPERATURE SELECTOR

PUSH TO START

BUTTON

SINGLE AND DUAL COIN

METER COIN SLOT AND KNOB

To reduce the risk of bodily injury, the
tumbler stops tumbling when the door is
opened. Do not use the tumbler if it does
not stop tumbling when the door is opened
or starts tumbling without pressing the
START pad. Remove the tumbler from use
and call for service.

W078

WARNING