Sony VGC-RA716GY - Manual (Page 187)

Your new hard disk drive is supplied with the necessary screws. Do not overtighten these screws when securing
the drive to the drive holder.
9. Align the drive holder with the tracks on the inside of the chassis. Slide the drive holder in completely.
10. Push the drive holder handle down to lock the drive into position.
11. Connect the second drive connector to the new drive. Orient the connector to align pin 1 on the red side of the
ribbon cable with pin 1 on the new drive.
12. Connect the second power connector to the new drive following the instructions supplied with the drive.
Replacing the driv e holder
13. Replace the side panel. See About Closing the Computer .
14. Reconnect the power cord to your computer.
Page 187